May 28, 2014

R&D - Saw-Cut Niobium Rings

This is something I had wanted to do even before I got my Ringinator :D

Specs

Niobium (yes, my favorite metal), 20 gauge AWG, half-hard, 0.2 oz, 144 coils on 3/32" mandrel, quick dips 3 times in anodizing bath, voltage 102, 85, 60, run thru Ringinator on 0.010" blade, with only soapy water and Rio Grande's Bur Life stick, loose rings anodized again at 35 volt for cut ends.


Counted 96 good ones.  Not bad for a first try.

What have I learned?
  1. Get some real cutting fluid for the Ringinator.  Niobium loads up very fast on the blade, even at this thin gauge...
  2. When cut by hand with a jeweler's saw, 8/o blades will do.  But do it in short coils, wrapped in masking tape; they heat up fast!
  3. Use low speed on the drill.  Gauge for gauge, temper for temper, niobium is harder to cut than bronze or sterling silver.
  4. Up the last anodizing voltage before cutting, to above 63, maybe, so that the final dip after cutting have more choices.
  5. For large volume of rings in common sizes, it's still more economical to buy them!!
I thoroughly enjoyed this experiment, and will definitely do it again.

What do you think? ;-)

.......



May 2, 2014

Ruffly Ribbon Strangemaille Pendant in Golden Fuchsia


Yes, this is a pendant that I created a while back, but never quite finished the whole piece, until now!


I really like this weave, Strangemaille, created by lorenzo of MAIL.  Seemingly random, but strangely consistent; I like the little wonkiness (is that a word? :-), and the softness both in look and feel.




But when it's centered on a delicate ball chain, it's totally prim and proper, be it on a white blouse....


or that cute little black dress!!

Pendant is 2" long, 5/8" wide, on 18" plated ball chain, with a 1" extension.

Make this your go-to necklace for the long, lazy summer to come!

This pretty pink pendant is now available for purchase in my online studio DaisyKreates.com.

Oh, and you are also looking for a something to go with this necklace, a finger ring perhaps?  Be sure to check this out as well.